READ ME FIRST! Follow these steps to get started with your remote control.Plug the charging cable intothe charging jack on theback/bottom of the remote.Plug the other end into aUSB power source. Thered charging indicatorilluminates. The greenindicator illuminates when theremote is fully charged.Manually turn on the device you want to control.Find the Code List that came with theremote. Locate the section for the type ofdevice you’re trying to program, and findyour brand in that section. Circle the codesfor your brand and keep them handy.If you don’t see your brand listed, consult theOwner’s Manual for other programming options.1 23VOLUME VOLUMEHDMI1 Test commonly used keys with the device.For TVs: test , VOL+, and (source/input). Try the key as well on Smart TVs.For streaming players: test (if applicable), , arrow keys and OK, and .If these keys work, congrats! You’ve finished programming for this key! If not, trysteps 4 and 5 with the next code for your brand in the code list.6For more information, including instructional videos, remote programming codes, and customer support,visit www.RCACodeSupport.comTo program the other device keys, follow these instructions again. For more detailed instructions, see theOwner’s Manual included in this package.RCTSC3B QSG 01 R341U1Press and hold the device key you want to programfor about 2 seconds, until the indicator lightilluminates and stays on. Then release the key.4 5 Use the keys in the middle of the remote asnumber keys as shown on the left.Enter the first five-digit code for your brand inthe code list (the indicator light flashes after eachdigit).= TV = Streaming playerTo program the remote to control a sound bar, press andhold the and at the same time until the indicator lightilluminates.152 436 879 0