RCA RCU403 User Manual

Also see for RCU403 - Universal Remote Control: Code List User manual User manual

Contents

5RCU800Program for TV—Direct Entry MethodSecondary Key Descriptions For AUDIO OperationsCertain keys on the eight-component universal remote have dual functions. Secondary key functionsare printed in blue on the remote and are used for AUDIO operations. Not all functions work for allbrands. Experiment with your AUDIO system to determine which functions work with yourcomponents. See the enclosed AUDIO Code List to operate your brand of equipment.Press the AUDIO key to enable the Audio Mode.AM•FM: allows you to select the AM•FM band on your AUDIO receiver.CD, TAPE, TUNER, TV, VIDEO 1, VIDEO 2: For some AUDIO systems, these keys will select thecorresponding component input.DELAY -, ON, DELAY +: increases or decreases the delay between the surround and main speakerswhen the receiver is in the Surround Sound Mode.DSP ON•OFF: enables the receiver’s Digital Signal Processing Mode.DSP MODE: When the DSP mode is enabled, pressing this key allows the user to cycle throughthe various DSP Modes.FRONT, CENTER, REAR, TEST: adjusts the levels of the front, center, and rear speakers usedwith LEVEL +/ LEVEL -. The test tone must be enabled first by pressing the TEST key.FUNCTION: selects the different AUDIO input components. The number keys also select thefunction labeled below the keys when in Audio Mode.LEVEL+/LEVEL-: sets the level of the speakers during Test Tone Mode.PRESET: cycles through preset channels while the Tuner input on your AUDIO system is active.In order for the eight-component universal remote to control your TV, you must program it with theTV code that matches your TV. These instructions explain the preferred method of programming theremote—the Direct Entry method. To program your remote to control your TV, follow these steps:ON•OFFTV CODECODESEARCHINDICATORLIGHT(BLINK)TV(OFF)1. Manually turn on the TV.2. Locate the enclosed TV Code List. Find your brand of TV.Note: If your brand is not listed, use one of the Code Searchmethods to program this remote control. (See section onCode Search.)3. Press and hold the CODE SEARCH key until the indicatorlight illuminates. Then release the CODE SEARCH key.4. Press and release the TV key. The indicator light blinksand then remains lit.5. Use the number keys to enter the first code listed for yourbrand. After you enter a valid three-digit code, the indicatorlight turns off.Note: If you enter an invalid code, the LED flashes rapidlyfor two seconds. Start over at step 3.6. Aim the remote at your TV and press the ON•OFF key.If your TV turns off, you have found the correct code.7. Enter the code in the box provided on this page forfuture reference.8. If your TV doesn’t turn off, repeat steps 3-6 above, enteringthe next code for your brand.If none of the codes work or your brand is not listed, useone of the Code Search methods to program this remote.(See Code Search section on page 11.)RCU800B_IB_REVB.qx4 2/11/04 13:05 Page 5