Place Batteries in the remote1. Remove the battery compartment cover.2. Place four AAA batteries as shown,matching the + and – end of each battery asindicated in the battery compartment.3. Replace the cover.Determine if your remote needs programmingSome RCA, GE and ProScan devices may already be pre-programmed.1. Press the button of the device you want tocontrol (for example TV).2. If the device turns on, press another button,to confirm (for example CHANNEL UP).3. If the device you selected (TV) responds,you will not need to program the remote.If the device you selected (TV) doesnot respond, you will need to programthe remote. (See pages 3-4 forprogramming instructions).4. Repeat steps 1-3 for other devices.Button DescriptionTVPOWERVCR2•LDVCR1SAT•CABLEAUDIOPLAY FFREWSTOP PAUSERECENTERDSPYMUTE PREV CHCHANVOLVOLCHAN1 2 36547 8 90INPUT TV•VCRUNEMPROGEDOCSRCHRAELCDONE••SWAPPIPFREEZEMOVE– +MOVE PIP5SYSTEMLINK AV•Code Search ButtonPrograms devices bysearching through brandcodes. Use when code listsare not available or whenthe listed code does notwork with your device.See page 3.Device Buttons(VCR1, VCR2•LD,SAT•CABLE, AUDIO, TV)Determines which deviceyou are controlling.Channel and Sound(DSPY, ENTER, VOL,CHAN, MUTE, PREV CH)Use these buttons to controlsound and channel changes.VCR Buttons(TV/VCR, REW, PLAY, FF,REC, STOP, PAUSE)Use these buttons to controlplayback from a VCR orLaserdisc Player. Also usedto record onto a VCR tape.Number Buttons (0-9)Use these buttons to directlyenter channel numbers for aTV, VCR and Cable Box.Also used for accessing pre-set channels of an AM/FMtuner or entering disk andtrack numbers for a CD play-er. Also used for enteringprogram code numbers frombrand lists.Setting Up Your Universal RemoteTVPOWERVCR2•LDVCR1SAT•CABLEAUDIO2Menu Buttons(MENU•PROG, MOVE, –, +,G, H) Use these buttons toadjust on-screen menufeatures and programminginformation.PIP Buttons(PIP, MOVE PIP, SWAP,FREEZE) Use these buttonsto adjust the Picture-inPicture feature if it isavailable on your TV.CHAN