RCA RCU900 User Manual

RCA RCU900 User Manual Manual pdf 23 page image

23The device you select for Volume Punch-through control mustbe either the TV or the AUDIO/AUX device programmed withthe Audio unit. Any other selection (VCR, DVD, SAT/CBL) isdenied and the LED indicator light flashes to indicate anerror. The power-on default for volume control is TV VolumePunch-through.Note: All Audio Modes take any Volume/Mute keypresscommands from the Audio code, even when the TV isprogrammed as the Punch-through device. All other devicespunch-through to the TV Volume/Mute control. When the Audiooption is chosen as the Punch-through device, all modes take anyVolume/Mute keypress commands from the Audio code.To change the device that controls the VOLUME and MUTE keysPunch-through, follow these steps:1. Press and hold the SETUP key on the rubber keypad until theLED indicator light remains on and the Main Setup Screen isshown. This process takes approximately 2-3 seconds.2. Release the SETUP key.3. Press and hold the device key on the rubber keypad forapproximately 5 seconds (TV or AUDIO/AUX) for volumecontrol until the LED indicator light blinks and the MainSetup Screen is shown.4. The default volume control is now set for the mode youhave chosen.VCR Punch-throughThe RCU900 punches through the six transport keys (REVERSE,PLAY, FORWARD, RECORD, STOP, and PAUSE) to VCR orDVD Mode, whichever was used most recently. Punch-throughto VCR/DVD transport keys on the rubber keypad is onlyallowed for TV, VCR, DVD, and Cable-coded Modes.AUX, SAT and CD/Audio are dedicated to theirprogrammed modes.In the VCR and AUDIO/CD Modes (including Punch-through),the RECORD key on the rubber keypad must be pressed twicebefore the command is sent. This is also true if a VCR device isprogrammed under any other mode. The exceptions are forDVD and SAT codes, where the RECORD key transmits thecommand after only a single RECORD keypress.Record KeyKeypress Beep FeatureYour RCU900 beeps whenever a key is pressed to acknowledgethe keypress. You can turn this feature on or off. The defaultsetting is On.To turn the Keypress Beep on or off, follow these steps:1. Press and hold the SETUP key on the rubber keypad untilthe LED indicator light remains on and the touchscreenshows the Main Setup Screen. This process takesapproximately 2-3 seconds.2. Release the SETUP key.3. Press and hold the MUTE key on the rubber keypad forapproximately 5 seconds until the LED blinks and the MainSetup Screen is displayed.Additional FeaturesRCU900_IB_revC.qxp 12/3/02 9:45 Page 23