RDS ICP 300 User Manual
              | |
ICP 300 IN-CAB PRINTER83.2 Connection - RDS 'Pro-Series'(Printer cable Pt No. S/CB/167-4-006)Depending on the product variant, connect the 9-way 'D' plug into either thetop port or the bottom port on the back of the head unit.A connector clamp is supplied to secure the plug in position.Product Port UsedLoadmaster 8000i / 8000iX TOPCeres 8000i BOTTOMPS Artemis BOTTOM3.3 SetupFor all RDS instruments, the default protocol settings for printer output are asfollows,Baud Rate 4800Data Bits 8Stop Bits 1Parity NoneHandshake RTSNOTE: The printer is not configurable.'Wizard' and 'G-Wiz'Depending on the product variant, there may be an 'ON/OFF' setting in theSetup menu to enable printer output.Please refer to the calibration manual for your instrument to configure printeroutput.Pro-Series, 'G-CAN' and 'ISOCAN'These instruments have 2 serial ports configurable for devices other thanprinters, such as GPS, barcode scanners etc. Depending on the softwaredefault settings for a particular product variant, it may be necessary to re-configure the port setting in the Setup menu to enable printer output.Please refer to the calibration manual for your instrument to configure printeroutput. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine