reedinstrumentswww com 6Pantone 534 BluePantone 123 YellowPantone 485 RedPantone 123 YellowPantone 534 BlueBlack Rich Black -20/20/20/100Blue - 100/80/30/5Yellow - 0/27/100/0Red - 10/100/100/5Yellow - 0/27/100/0Blue - 100/80/30/5Pantone 534 Blue - 100/80/30/5the temperature reading will automatically show on the LCD screen.3. Release the Trigger and the HOLD display icon will appear on theLCD indicating that the current measurement is being held on thescreen. For continuous testing hold the button down.4. The meter will automatically power down after approximately 15seconds of inactivity.ApplicationsApplications for this product include food preparation, safety and fireinspectors, plastic molding, asphalt, marine and screen printing, measureink and dryer temperature, HVAC/R, diesel, fleet maintenance andmuch more.MODE Button FunctionThis infrared thermometer measures Maximum (MAX), Mini-mum (MIN), Differential (DIF), and Average (AVG) Tempera-tures. Each time you take a reading, the last nine (9) readingsare stored and can be recalled by pressing and holding theMODE button. When the trigger is pulled again, the unit willbegin measuring in the last mode selected. Pressing theMODE button also allows you to access the High Alarm(HAL), Low Alarm (LAL) & Emissivity (EMS). Each time youpress MODE, you advance through the mode cycle. Thediagram on the left shows the sequence of functions in theMODE cycle.Switching SettingsSelect the temperature units (°C or °F) by pressing and holding down thebacklight / laser / °C / °F (button #2 on instrument diagram).To set values for the High Alarm (HAL), Low Alarm (LAL) and Emissiv-ity (EMS), firstly activate the display by pulling the trigger or pressingthe MODE button, then press the MODE button until the appropriateselection appears in the lower left corner of the display, press the UP andDOWN buttons to adjust the desired values.HALLALMAXMINMODEAVGDIFEMS1.888.610.7664info@REED-Direct.com REED-Direct.com