Rabbit 2000 Getting Started Manual
Also see for 2000: Getting started manualReference manualUser manualGetting startedDesigners handbook
                                                  | |
Contents
| 
12 Rabbit 2000 Development Kit2.3.2 Connect Programming CableThe programming cable connects the Jackrabbit to the PC running Dynamic C to down-load programs and to monitor the Jackrabbit during debugging.Connect the 10-pin connector of the programming cable labeled PROG to header J3 onthe Jackrabbit board as shown in Figure 3. Be sure to orient the marked (usually red) edgeof the cable towards pin 1 of the connector. (Do not use the DIAG connector, which is usedfor a normal serial connection.)NOTE: Use only the programming cable that has a red shrink wrap around the RS-232level converter (Z-World part number 101-0513), which is supplied with the Develop-ment Kit. Other Z-World programming cables might not be voltage-compatible or theirconnector sizes may be different.Figure 3. Power and Programming Cable Connectionsto Jackrabbit BoardConnect the other end of the programming cable to a COM port on your PC.NOTE: Some PCs now come equipped only with a USB port. It may be possible to use anRS-232/USB converter with the programming cable supplied with the Jackrabbit Devel-opment Kit. Contact Technical Support (see Section 2.5.1) for further assistance. "% *+,-./0& ! !' )' ( 8::54' %%*,*+2-35-2,5/23?5/*?*+4 +*;+8AA5/;0*//204*+58;/*34500*//204*+ |
Related manuals for Rabbit 2000
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine