Radio Shack HTX-400 Owner's Manual

Also see for HTX-400: Owner's manual Service manual

212. To change the frequency, hold down C until and C flash.3. Directly enter or press or to select the desired fre-quency. If you want to enter a repeater frequency see“Understanding Repeaters” on Page 17.4. Press C to store the selected frequency in memory.5. To program the repeater offset for the selected frequency,press FUNC+SC. To change the value, press or . Select0 Hz if you want to remove the offset. To store the setting,press C or PTT.While and C appear, you can program other settingssuch as CTCSS tones (see “Using Subaudible ToneSquelch” on Page 24.)To enable the calling frequency, press C at any time. The trans-ceiver immediately goes to that frequency with the settings youprogrammed. To exit the calling frequency mode, press C again.USING STANDARD MEMORIESYour transceiver has 30 standard memories that you can use tostore frequencies for quick access. You can also store other set-tings such as repeater offset, CTCSS tones, and frequencies topass or lock out during scanning.Storing a Transmit/Receive Frequency1. Press MR to enter the memory setting mode. and the lastused memory location appear.2. Repeatedly press or to select the desired memorylocation. ------ appears if the memory location is empty.3. Press FUNC+MR. The selected memory location andflash.MRMRMRMR19-1102.fm Page 21 Friday, March 19, 1999 4:08 PM