Radiwarm 3100 Installation & Operating Instructions Manual
                   | |
Contents
| 
Page 6DocumentRADiWARM - OperatorRevision0501M077.LDate19/06/20193.2 FittingEnsure that the brackets are fitted towards the outside of the hangers onthe radiator. This will prevent any lateral movement when the radiator ismounted.To install the radiator at the recommended minimum height, the bottom ofthe wall fixing bracket should be approximately 200mm from the floor (seediagram and table above). To allow for other heights above the floor, notethat the bottom of the fixing bracket is approximately 50mm above thebottom of the radiator.For most efficient operation of the radiator, there should be a gap betweenthe skirting board and the rear panel of the radiator to allow air flow behindthe radiator. If the bottom of the radiator is below the top of the skirtingboard, it may be necessary to remove a section of skirting for this purpose.AA*Note: * dimensions for additional bracket for radiators 2000mm long only.200mm recommended, 150mm minModel 3100 3140 3160 4100 4140 4160Bracket Width (mm) 734 1134 1334 734 1134 1334A* (mm) - - - - - -Weight (kg) 25 33 35 33 44 50Model 6040 6060 6080 6100 6120Bracket Width (mm) 134 334 534 734 934A* (mm) - - - - -Weight (kg) 25 29 40 50 58 |
manualsdatabase
Your AI-powered manual search engine