Rain Bird ESP-LX Plus Series Installation, Connection And Settings

INSTALLING THE MISB DATA ANDPOWER CABLEThe ESP-LX PLUS cabinet has five knockouts for routingfield wires. Three are located on the underside of the cab-inet and two are located on the back• The underside of the cabinet has a knockout for a PVCmale adapter sized 3⁄4" (1,9 cm) on the right hand sideof the controller. This is the hole to be used for routingof the MISB Data and Power Cables from the LX-PlusController. Conduit is recommended between the twocabinets.• Run the MISB data (end without the ferrite bead) andpower cables between the two cabinets. There shouldbe 36” (91.4 cm) of cable available, external to the twocabinets. Recommended conduit run is 6” (15,2 cm)vertical under each cabinet. Horizontal distance isbased on cabinet mounting - recommended minimumdistance between cabinets is 91⁄2” (24,1 cm).In the MISB Cabinet:• The bottom (center) of the MISB Cabinet has a knock-out for a PVC male adapter sized 1” (2,5 cm) surround-ed by a knockout for a 11⁄4” (3,2 cm) adapter. The 1”(2,5 cm) knockout is what is to be used for routing theMISB data and power cables into the MISB Cabinet. Ifusing conduit, you will need a 1⁄2” (1,9 cm) to 1” (2,5cm) conduit adapter to upsize the conduit to fit theknockout. Note: the right-hand 3⁄4" (1,9 cm) knockoutwill be used for sensor and phone cables.• Plug the three-wire (black, white, and green) powercable into the J4 connector on the bottom edge of theMISB, to the left of the sensor ports. Note: If you have a240 VAC, 50 Hz controller your power cable will onlyhave two-wires (black and white).• Connect the six-wire cable to the J1 connector on theMISB.ESP-LX Plus Site Satellite Controller Addendum8