Rainforest Automation EMU-2 Technical Manual
Also see for EMU-2: User manualQuick start guideQuick start guideQuick start guide
                        | |
Contents
| 
EMU-2™Technical Manual4Regulatory informationFCC NoticesThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause undesired operation. Changes or modifications notexpressly approved by the manufacturer could void the user’s authority to operate the equipment.FCC/IC RF Exposure StatementThis equipment complies with FCC and Industry Canada radiation exposure limits set forth for anuncontrolled environment. The antenna(s) used for this equipment must be installed to provide aseparation distance of at least 8 inches (20cm) from all persons.ICES-003 ComplianceThis Class B digital apparatus complies with Canadian ICES-003.Note: This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected. Consult the dealer or an experienced radio/TV technician for help.Compliance Regulations For Australia and New ZealandThis equipment complies with the C-Tick labeling requirements for Australia and in New Zealand. As aradio transmitter, this device complies with the requirements of AS/NZS 4268:2008 as designated in theRadiocommunications (Short Range Devices) Standard 2004 for Australia and as required by theRadiocommunications Regulations (General Users Radio License for Short Range Devices) Notice 2011for New Zealand. This device is a Category A device as defined in the Radiocommunications(Compliance Labeling - Electromagnetic Radiation) Notice 2003. |
Related manuals for Rainforest Automation EMU-2
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine