Rainfresh QS2 Installation And Operating Instructions Manual

Also see for QS2: User manual

Contents

troubleshooting

Rainfresh QS2 Installation And Operating Instructions Manual Manual pdf 1 page image

INSTALLATION (Please read carefully before proceeding)Contents Included:Filter assembly, faucet & faucet parts bag, parts kits bag with saddle valve, battery, mounting screws (3), tube compression fittings,1/4” union tee connector, 19 feet of 1/4” OD tubing (5 ft for models QS2 & QS2X), installation/operating instructions.Installation shall comply with applicable plumbing codes and regulations. This unit comes complete with all necessary fittings to install the unitbelow the counter to copper or CPVC rigid plastic pipe. The water supply saddle valve is included for use in areas where codes permit. Where notpermitted, the installer must provide approved fittings to tap the cold water pipe for a feed water source to the filter system (must adapt to ¼” ODtubing).INSTALLATION NOTES AND CAUTIONS1. The system is designed for point-of-use (POU) under-sink installation for single faucet dispensing. However the unit can beinstalled in a remote location with tubing running up to the faucet. Note: additional tubing (not included) may be required.2. Installation of this unit may involve some water spillage. Keep an ample supply of paper towels or an absorbent cloth handy.3. This system is intended for use with cold water only. DO NOT INSTALL ON HOT WATER.4. Protect filter from direct sunlight. Not intended for outdoor use.5. Protect unit from freezing.6. Not intended for installation in multi-storey buildingsTOOLS REQUIRED FOR INSTALLATIONDrill (cordless or electric), ½” drill bit, adjustable wrenches, Phillips and flat screwdrivers, utility knife, pencil.1.UNPACKING THE UNITRemove both cartridges by turning them 1/4 turn clockwise, then pulling away from headassembly. Place them aside in a safe place until final assembly.MOUNTING THE FAUCET (See Fig. 2)Faucet may be installed in hole in sink (if available) or in counter top. Note: The faucet mayalso be installed in the sink sprayer hole if available.1. Position faucet on counter top beside sink in desired position. Ensure that swivel spout willextend over sink and that there is room under the counter for faucet shank and to tightennuts.2. Mark the location and drill a ½” hole. Protect your counter top by applying a layer ofmasking tape and use a sharp drill.3. Insert faucet shank through escutcheon plate (1040-9) and escutcheon washer (1040-10),and then through counter top. Install plastic locating washer(1040-12), lock washer(1040-13) and locking nut (1040-14). Tighten locking nut securely while someone holds thefaucet body so it does not turn.726-01/4” tube1008-316031040-141040-131040-121040-91040-10Counter Top ComptoirFig. 2INSTALLATION AND OPERATING INSTRUCTIONS MODEL QS2, QS2K, QS2X (Please save for future reference.)INTRODUCTIONYour Rainfresh TWIST Dual Drinking Water System uses a premium dual-stage filtering process,providing cleaner, safer, better tasting drinking water for your family. It reduces lead, VOC(volatile organic compounds), cysts, chloramines, chlorine, bad tastes and odours(see performance data sheet for details)*. The system is designed for installation under thekitchen sink and includes a ceramic-disc faucet for dispensing filtered water.*Contaminants reduced by this system are not necessarily in your water.A fridge connection kit is included with the QS2K system in case you choose to also havefiltered water from your water-dispensing fridge and for your ice cubes.The “Twist ON/Twist OFF” design makes cartridge replacement quick and easy, using no toolsand without having to shut off the water.Both cartridges should be replaced after 250 gallons (946 liters) or 4 months**. The systemfeatures a unique electronic monitor (QS2 & QS2K only) that tracks both the gallons used andtime in service and triggers a blinking orange LED when either of these limits is reachedadvising you to replace the cartridge.**Note: Cartridge life is directly dependant on water conditions and volume of water filtered. Excessive sediment may cause more frequent replacement.