Manual-4Mic Input• Balanced ¼" TRS input (Tip (+), Ring (–), Sleeve (ground)• Accepts unbalanced ¼" TS (Tip-Sleeve) plugs.• Mic Engage switch turns the Mic on and off without changing the Mic level.° Green indicator lights when engaged.• MIC level control range is Off to +50 dB• Overload Indicator:° Lights 3 dB before clipping.° Monitors the signal level before and after the HI and LOW tone controls.° If it lights, turn the MIC level down and/or reduce the tone control boost.• 2-band tone control:° Maximum boost: 12 dB.° Maximum cut: -12 dB.° Center frequency: 1 kHz.• FlexFX effects loop:° WET (effect), DRY (no effect) pan control.° Process mic with any combination of input channels.° See FlexFX Effects Loop section for details.AUX Input and Output• AUX Input:° Unbalanced RCA jack.° AUX CUE signal is sent to the cue circuit before the AUX IN level control.° AUX IN level control range is Off to +10 dB.° AUX input sums to the Master mix after the Crossfader and FlexFX loop.• AUX Output:° Unbalanced RCA jack.° AUX OUT control range is Off to +0 dB° Source is the Master mix:Program 1, 2, 3 (pre- or post-effects)plus the Mic (pre- or post-effects)plus the AUX Input.Booth Output• Balanced ¼" TRS output• Level control range is Off to +6 dB• Source is the Master mix:Program 1, 2, 3 (pre- or post-effects)plus the Mic (pre- or post-effects)plus the AUX Input.Main Output• Balanced XLR output.• Level control range is Off to +6 dB.• Source is the Master mix:Program 1, 2, 3 (pre- or post-effects)plus the Mic (pre- or post-effects)plus the AUX Input.100+12-122486OL+12-12AUX INDRYLOWWETCUEAUXHIMICMICMIC ENGAGEAUTO-GAININPUT1-2-31002486AUX OUTBOOTHMAIN100248610024861002486