Rangemaster 110 Gas User's Manual & Installation Instructions

Also see for Classic 110: User guide User guide Installation and user guide User's guide & installation instructions User guide & installation & service instructions

24base (Fig.7.5). Repeat from the back and remove the rear halfof the polystyrene base.Lowering the Two Rear RollersTo adjust the height of the rear of the cooker, first fit a 13mm spanner or socket wrench onto the hexagonal adjustingnut (Fig.7.6). Rotate the nut – clockwise to raise – counter-clockwise to lower.Make 10 complete (360°) turns clockwise.Make sure you lower BOTH REAR ROLLERS.Completing the MoveUnfold the rear edge of the cardboard base tray. Open thegrill door and right-hand oven door so that you can get agood grip on the bottom of the fascia panel as you move theoven (Fig.7.7).Carefully push the cooker backwards off the cardboard base.Remove the base tray.Position the cooker close to its final position, leaving justenough space to get behind it.nn Do not use the door handles or control knobs tomanoeuvre the cooker.Fitting the Stability Bracket or ChainUnless otherwise stated, a cooker using a flexible gasconnector must be secured with a suitable stability device.Suitable stability devices are shown in Fig.7.8, Fig.7.9 andFig.7.10.If you are using a stability chain (Fig.7.8) then the chainshould be kept as short as is practicable and fixed firmly tothe rear of the cooker.If you are using a stability bracket (Fig.7.9 and Fig.7.10), thenadjust the bracket to give the smallest practicable clearancebetween the bracket and the engagement slot in the rear ofthe cooker.Fit the bracket so that it engages as far as possible over thechassis of the cooker.Repositioning the Cooker followingConnectionIf you need to move the cooker once it has been connectedthen you need to unplug it and, having gripped under thefascia panel and lifted the front of the cooker slightly(Fig.7.7), you need to check behind the cooker to make surethat the gas hose is not caught.As you progress, make sure that both the electricity cable andgas hose always have sufficient slack to allow the cooker tomove.With a stability chain fitted, release it as you ease the cooker out.Do not forget to refit it when you replace the cooker.When you replace the cooker, again check behind to makesure that the electricity cable and gas hose are not caught ortrapped.INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.Stability chainArtNo.070-0014 - Stability bracket - Wall fittingCookerStability bracketFloor3 mm minTypical floor mountingCookerOuter stabilitybracketFloorWall3 mm minTypical wall mountingTypical floor mountingTypical wall mountingFig.7.6Fig.7.7Fig.7.8Fig.7.9Fig.7.10