Rangemaster Classic Deluxe 110 User's Manual & Installation Instructions

Also see for Classic 110 Deluxe Duel Fuel: User guide User's guide & installation instructions User's guide & installation instructions Users guide & installation User's guide & installation instructions

30INSTALLATIONCheck the appliance is electrically safe and gas sound w hen you have nished.ArtNo.215-0026 - Handle gaskets fixedArtNo.210-0006 - Classic fitting the handles 2Fitting the Handles and HandrailRemove the 4 mm Allen screws from the doors (Fig. 8.11). Fitthe door handles and secure using the 4 mm screws(Fig. 8.12).nn The handles should be above the fixings.Remove the 4 mm Allen screws from the top corners of thefascia (Fig. 8.13). Fit the front handrail in position and secureusing the 4 mm screws.LevellingYou are recommended to use a spirit level on a shelf in one ofthe ovens to check for level. Place the cooker in its intendedposition taking care not to twist it within the gap betweenthe kitchen units as damage may occur to the cooker or theunits. The front feet and rear rollers can be adjusted to levelthe cooker. To adjust the height of the rear of the cooker usea 13 mm spanner or socket wrench to turn the adjusting nutsat the front bottom corners of the cooker.To set the front, turn the feet bases to raise or lower.Gas ConnectionThis must be in accordance with the relevant standards.The flexible hose (not supplied with the cooker) must bein accordance with the relevant standards. Hoses may bepurchased at most builders’ merchants.The gas supply needs to terminate with a down-facingbayonet. The connector is located just below the hotplatelevel at the rear of the cooker. If in doubt contact yoursupplier.The rear cover boxes limit the position of the supply point.Because the height of the cooker can be adjusted andeach connection is different, it is difficult to give precisedimensions.Although a 900 mm hose can be used, a 1250 mm hosewill allow slightly more flexibility in the positioning of thebayonet and make moving the cooker easier.The hose should be fitted so that both inlet and outletconnections are vertical so that the hose hangs downwardsin a ‘U’ shape. Ideally the hose supply connection should bewithin the shaded area ‘A’ (Fig. 8.14).For Natural Gas, the flexible hose must be in accordance withBS 669. For LP Gas, it should be capable of 50 mbar pressure,70 °C temperature rise, and carry a red stripe, band or label. Ifin doubt contact, your supplier. Screw connect the threadedend of the hose into the gas inlet. After completing the gasconnection, make sure that the cooker is gas sound with apressure test.Pressure TestingThe gas pressure can be measured at one of the hotplateburner injectors (not a wok burner). Lift off a burner head. Fitthe pressure gauge to the injector. Turn on and light one ofthe other hotplate burners. Turn on the control knob for theburner with the pressure gauge fitted to let gas through.Art No 215-0028 - Handrail fascia fixings470350675A315All dimensions in millimetresGas inletFig. 8.11Fig. 8.12Fig. 8.13Fig. 8.14