Rangemaster Classic Deluxe 90 Installation And User Manual

Also see for 90 Dual Fuel: User guide User guide Users guide & installation User guide User's guide & installation instructions

Rangemaster Classic Deluxe 90 Installation And User Manual Manual pdf 32 page image

INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.28Pressure TestingThe gas pressure can be measured at one of the hotplateburner injectors (not a wok burner).Lift off a burner head. Fit the pressure gauge to the injector.Turn on and light one of the other hotplate burners.Turn on the control knob for the burner with the pressuregauge fitted to let gas through.See the data badge for test pressures.Turn off the burners. Make sure that you reassemble theburner top in the correct way on the burner body.Electrical ConnectionThe cooker must be installed by a qualified electrician, inaccordance with all relevant British Standards/Codes ofPractice (in particular BS 7671), or with the relevant nationaland local regulations.Current Operated Earth Leakage BreakersThe combined use of your cooker and other domesticappliances may cause nuisance tripping, so werecommend that the cooker is protected on an individualRCD (Residual Current Device) or RCBO (Residual CurrentBreaker with Overload).IF IN DOUBT, PLEASE CONSULT A SUITABLY QUALIFIEDELECTRICIAN.Note: The cooker must be connected to the correct electricalsupply as stated on the voltage label on the cooker, througha suitable cooker control unit incorporating a double-poleswitch, having a contact separation of at least 3 mm in allpoles.nn The cooker MUST NOT be connected to an ordinarydomestic power point.Access to the mains terminal is gained by removing theelectrical terminal cover box on the back panel. Connectthe mains cable to the correct terminals for your electricalsupply type (Fig.7-12 and Fig.7-13). Check that the links arecorrectly fitted and that the terminal screws are tight. Securethe mains cable using the cable clamp.Final ChecksHotplate CheckCheck each burner in turn (refer to the ‘Hotplate Burners’section at the front of the instructions).Grill CheckTurn on the grill control and check that the grill heats up.Oven CheckSet the clock as described earlier in the instructions, and thenturn on the ovens. Check that the oven fans start to turn andthat the ovens start to heat up.Note: The oven light bulb is not included in the guarantee.Turn off the oven.ArtNo.130-0010 Electrical connections single-phaseLN230 V ac 50 Hz10 mm² max6 mm² maxFig.7-12L1NL3L23N ac230/400 V 50 Hz6 mm² max10 mm² max6 mm² maxFig.7-13