Rangemaster Nexus 110 Dual Fuel User's Manual & Installation Instructions

Also see for Nexus 110 Induction: User's guide & installation instructions

Rangemaster Nexus 110 Dual Fuel User's Manual & Installation Instructions Manual pdf 41 page image

37INSTALLATION Check the appliance is electrically safe and gas sound when you have finished.ArtNo.110-0004 - 110 Cooker min spacings5 mm 5 mmHeight to Hotplate905 mm min930 mm maxHeight to Flue Trim920 mm min945 mm max650 mm min410 mm min 410 mm min1102 mm1092 mmWall Wallcheck cookerhood instructions for actual dimensions75 mm min 75 mm minPositioning the CookerFig. 7.1 and Fig. 7.2 shows the minimum recommendeddistance from the cooker to nearby surfaces.The cooker should not be placed on a base.Fig. 7.1 and Fig. 7.2 Cookers installed into recess: The cookermust have side clearance ABOVE hob level of 75mm up to aheight of 410mm. This can be reduced to 25mm if the surfaceis made from a non-combustible material.A minimum space of 650 mm is required between the top ofthe hob and a horizontal combustible surface.*Any cookerhood should be installed in accordance with thehood manufacturer’s instructions.**Any splashback must be fitted in accordance with themanufacturers instructions. Allowance should be made forthe additional height of the flue trim, which is fitted to thecooker hob.Surfaces of furniture and walls at the sides and rear of theappliance should be heat, splash and steam resistant. Certaintypes of vinyl or laminate kitchen furniture are particularlyprone to heat damage and discolouration. We cannot acceptresponsibility for damage caused by normal use of thecooker to any material that de-laminates or discolours attemperatures less than 65 °C above room temperature.DO NOT box the cooker in – it must be possible to move thecooker in and out for cleaning and servicing.To allow the oven doors to open, a clearance of 130 mm isrequired if the cooker is near a corner of the kitchen (Fig. 7.3).The actual opening of the doors is slightly less, but this allowsfor some protection of your hand as you open the door.Moving the Cookern On no account try and move the cooker while it isplugged into the electricity supply.n The cooker is very heavy, so take great care.We recommend that two people manoeuvre the cooker.Make sure that the floor covering is firmly fixed, or removed,to prevent it being disturbed when moving the cookeraround.To help you, there are two levelling rollers at the back, andtwo screw-down levelling feet at the front.Remove the polystyrene base pack. From the front, tiltthe cooker backwards and remove the front half of thepolystyrene base (Fig. 7.4).Repeat from the back and remove the rear half of thepolystyrene base.130 mm minArtNo.110-0004 - 110DF - Cooker min spacings75 mmmin75 mmmin650 mmmin905 mmmin930 mmmaxFig. 7.1Fig. 7.2Fig. 7.3Fig. 7.4