Rangemaster R7247 User Manual & Installation & Service Instructions

Contents

5ArtNo.303-0005 Setting the end timeArtNo.303-0006 Adjusting the beep volumePress the timer key for about 3 seconds. Press the key twiceagain until ‘End’ appears in the display (Fig.2-8). Using the ‘+’and ‘–‘ keys, set the required ‘stop time’.To Start and then Stop the Oven using the TimerThis is a semi-automatic function that allows you to set the‘cook time’, which is the duration you want the oven to cookfor and the ‘stop time’, which is the time of day at which youwant the oven to stop cooking.You cannot set a start time directly – this is set by acombination of the ‘cook time’ and ‘stop time’.Press the timer key for about 3 seconds. Press the key againuntil ‘dur’ appears in the display (Fig.2-7). Using the ‘+’ and ‘–‘keys, set the required ‘cook time’. Wait a few seconds for thesettings to be memorised.Press the timer key for about 3 seconds, then press the keytwice again until ‘End’ appears in the display (Fig.2-8). Usingthe ‘+’ and ‘–‘ keys, set the required ‘stop time’.Note: Make sure to set the temperature control to the correctcooking temperature.The oven will beep when it stops cooking. To stop the beeperwhen it sounds, press any of the clock buttons.Adjusting the Beep VolumeTo adjust the beep volume, press the ‘+’ and ‘–‘ keyssimultaneously, then press and hold the central timer buttonuntil ‘ton 1’ flashes in the display (Fig.2-9). Press the ‘–‘ key toscroll through the volume settings:• Ton 1: High volume• Ton 2: Medium volume• Ton 3: Low volumePress the central timer key to set the volume.Oven AccessoriesThe oven is supplied with two wire shelves and an enamelledgrill pan, with a trivet and a handle. The wire shelves slide intothe wire supports located on either side of the oven interior(Fig.2-10).Removing the ShelfPull the shelf forward until the back of the shelf is up to theshelf stop (Fig.2-11). Lift the front of the shelf so the stopclears the wire support and pull clear (Fig.2-12).Refitting the ShelfTo refit the shelf, line up the shelf with the shelf supports andslide it between the two support wires until the shelf stop hitsthe wire support. Lift the front of the shelf so that the stopclears the support, then lower the front so that the shelf islevel and push it back fully.The shelf guard should be at the back pointing upwards.Fig.2-8Fig.2-9ArtNo.325-0033 Oven BI shelf��ArtNo.325-0034 - Fitting the shelf 1ArtNo.325-0035 - Fitting the shelf 2Fig.2-10Fig.2-11Fig.2-12A – Shelf guard, B – Front, C – Shelf stopKey