en-5INTRODUCTION 22.3GUIDELINES FOR THE DISPOSAL OF SCRAP PRODUCTS _____________________2.3.1 DURING SERVICE LIFE _______________________________________________Used oil, oil filters and engine coolant are hazardous materials. Recommended procedures must be followed for theirsafe removal.If a fluid leaks, contain the spill to make sure that the leak does not flow into the ground or drainage system. Follow thelocal laws to make sure that leaks are controlled safely.The maintenance procedures in this manual make sure that the damage that the machine can cause in the localenvironment is controlled safely.When the machine completes its full service life, the following actions must be taken.2.3.2 END OF SERVICE LIFE _______________________________________________These guidelines must be used with applicable Health, Safety and Environmental laws. Always use the approved localwaste disposal and agencies for recycled materials.• Park the machine in a location to use all of the necessary lifting equipment.• Use correct tools and Personal Protective Equipment (PPE) and take instruction from the technicalmanuals applicable to the machine.• Remove and store correctly1. Batteries2. Fuel3. Engine coolant4. Oils• Disassemble the structure of the machine and refer to the technical manuals where applicable. Giveattention to parts that have mechanical pressure or tension applied to the part in the machine, includingsprings.• Items that continue to have a service life must be separated and returned to the local store.• Items that are worn must be separated into the material groups and removed according to the agenciesfor recycled materials that are available. Common types are as follows:• Steel• Non ferrous metals• Aluminium• Brass• Copper• Plastic materials• Identified• Can be recycled• Can not be recycled• Not identified• Rubber• Electrical and Electronic Components• If an item is not easily separated into different material groups, the material must be added to the“General discarded materials” area.• Do not burn discarded materials.Change the machinery records to show that the machine is not in service and is discarded. Supply this serial number toRansomes Jacobsen Warranty Department to close their records.