en-24RANSOMES PARKWAY 2250 PLUSSAFETY AND OPERATORS MANUAL6.13 INSTRUMENT PANELA. ENGINE PREHEAT INDICATOR LAMPColour green, on when the ignition switch is turnedclockwise to the pre-heat position. Once the lampgoes out the engine can be started.B. ENGINE TEMPARATURE GUAGEIndicates current temparature of engine, whilstrunning.C. ENGINE OVERHEAT WARNING LAMPColour red, on when the engine temperature reachesa preset level. If the lamp comes on and a warninghorn is sounded bring to machine to a stop,disengage the cutting cylinders, apply the parkingbrake and allow the engine to cool by running theengine at half speed for two minutes before stoppingand investigating the cause.D. CHARGING WARNING LAMPColour red, on when ignition is switched on and will goout when the engine is started. If the light comes on whilethe engine is running, the fan belt may be slipping orbroken or a fault in the electrical system is indicated andshould be investigated. STOP IMMEDIATELY.E. ENGINE OIL PRESSURE WARNING LAMPColour red, on when the ignition is switched on, and willgo out once the engine has started. If the light comes onwhile the engine is running - STOP IMMEDIATELY asthis indicates that the engine oil pressure is too low.Check the level of oil in the sump and top up asnecessary. Check the oil pressure sender switch.Continued operation may cause extensive damage to theengine.F. 4 WHEEL DRIVE IN REVERSE SWITCHPress and hold the bottom half of the switch toengage 4 wheel drive when reversing. (Wherefitted). This function only operates when in cuttingmode.G. HEAD LIGHT/SIDE LIGHTDepress the bottom half of the switch to turn on theheadlights and sidelights. (Where fitted)H. DIRECTIONAL INDICATORSDepress left hand-side of switch to signal left, andright hand-side of switch to signal right. (Wherefitted)I. HAZARD WARNING LIGHTS.Press the top half of the switch to turn on the hazardwarning lights. (Where fitted)6 CONTROLS