RapidWave RapidLink 54 User Installation Manual/users Manual
Also see for RapidLink 54: Installation guide & user manual
                           | |
RapidLink 54 Wireless Point-to-Multipoint Networks10 Installation GuideTip For best results, secure this cable to the pole at least every 10 feet with tie-wraps.3.3 Connecting the Indoor Units (Power-over-Ethernet Injectors)The indoor unit is the point at which the outdoor units connect with your indoor LAN. More specifically, the indoor unitconnects your wireless unit to the network and transmits both data and power to the outdoor unit.Perform the following steps (1-6) to connect the indoor unit of the wireless outdoor unit.Step 1: Place the indoor unit in an appropriate location that meets the following criteria:ß The distance from the outdoor unit to the indoor Power-Over-Ethernet adapter must not exceed the length ofyour Ethernet cable after attached to the bottom of the outdoor unitß The distance from the indoor unit to the Ethernet network backbone device (e.g., hub or switch) must notexceed 320 ft (100 meters)ß The distance from the indoor unit to an available AC outlet must not exceed the length of the supplied powercableStep 2: Bring the Ethernet cable into to the wiring closet (where the indoor unit is located), and plug the RJ-45connector into the combined Ethernet/power output port (P + Data Out) on the front panel of the indoor unit. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine