Dominion KX II Quick Setup Guide 2QSG-DKX2-v2.5.0-0M-E 255-62-4022-00-RoHS5. When connecting cables to the rear panel of the userstation or switch, drape them over the cable-support bar.Front rackmountFront rackmountQS R uleRear MountNote: The Raritan device used in the diagrams shown hereare for example purposes only, and may not be a picture ofthe KX II device. However, the mounting instructions areconsistent.The steps correspond to the numbers shown in the rearrackmount diagrams.1. Secure the cable-support bar to the front end of the sidebrackets, near the side brackets' “ears,” using two of theincluded screws.2. Slide the user station or KVM switch between the sidebrackets, with its rear panel facing the cable-support bar,until its front panel is flush with the back edges of the sidebrackets.3. Secure the user station or switch to the side bracketsusing the remaining included screws (three on each side).4. Mount the entire assembly in your rack and secure theside brackets' ears to the rack's front rails with your ownscrews, bolts, cage nuts, and so on.5. When connecting cables to the rear panel of the userstation or switch, drape them over the cable-support bar.Rear rackmountRear rackmountQS R uleStep 1: Configure the KVM Target ServersFor optimal bandwidth efficiency and video performance, KVMtarget servers running graphical user interfaces such asWindows®, Linux®, X-Windows, Solaris™, and KDE mayrequire configuration. The desktop background does not needto be completely solid, but desktop backgrounds featuringphotos or complex gradients might degrade performance.Ensure that the server video resolution and refresh rate aresupported by KX II and that the signal is non-interlaced. TheKX II supports these resolutions:Resolutions640x350 @70Hz 1024x768@85640x350 @85Hz 1024x768 @75Hz640x400 @56Hz 1024x768 @90Hz640x400 @84Hz 1024x768 @100Hz640x400 @85Hz 1152x864 @60Hz