Rath VoIP Command Center Installation & Operation Manual

Also see for Command Center: Installation & operation manual Installation & operation manual Installation & operation manual Installation & operation manual

Contents

Rath VoIP Command Center Installation & Operation Manual Manual pdf 6 page image

Page 6Option 264-128 Zone VoIP System:• Plug the supplied RJ45 pigtail cables into the RJ45 interface connections following the wiring chartand pin-out color scheme below• Refer to the top of the cards to see what type of RJ45 interface and number of extensions• The same pin-out color scheme should be used for the primary card and for all additional cards.The system uses T568-A for pin-out wiring• On top of each card there is a table indicating RJ45 interface usage:S_ are the ports used for connecting hardwired Call BoxesTD(1-2)(3-4) with a dot under the D is the port used for connecting Command Center phone(s)TD(1-2)(3-4) with a dot under the T is the port used for outside Telco lines• The first card installed will always be:• Interface 1 (S01-S04): connection for 4 hardwired emergency phones• Interface 2 (S05-S08): connection for 4 hardwired emergency phones• Interface 3 (S09-S12): connection for 4 hardwired emergency phones• Interface 4 (S13-S16): connection for 4 hardwired emergency phones• Interface 5 (D1-2): connection for up to 2 Command Center phones• Interface 6 (T1-2): connection for up to 2 outside Telco lines• Connect the WAN port on the control card to the network components via an ethernet cableS01-S04 S05-S08 S09-S1220032004COMMAND CENTER 1COMMAND CENTER 22001 2002PHONE 1PHONE 2PHONE 3PHONE 4Note: Do not usethe green andbrown pairsS13-S16 D1-2 T1-2200720082005 2006PHONE 5PHONE 6PHONE 7PHONE 8201120122009 2010PHONE 9PHONE 10PHONE 11PHONE 12201520162013 2014PHONE 13PHONE 14PHONE 15PHONE 16TELCO LINE 1TELCO LINE 2