Raven Sidekick Pro Installation & Operation Manual
Also see for Sidekick Pro: Quick Installation ReferenceInstallation and operation manualInstallation and operation manualInstallation & operation manual
                                                                                      | |
Contents
| 
Chapter 426 Sidekick Pro Installation & Operation ManualMeter CalThe meter cal value for the Sidekick Pro injection pump may be found on the label located on the pump motor.Enter this value as the initial meter cal in the control console.Note: The meter cal may be adjusted to refine calibration of the chemical injection pump. Refer to theCalibrate the Injection Pump section on page 32 to check or refine the meter cal.FIGURE 1. Sidekick Pro Pump Motor Label with Meter CalValve Type and Valve CalThe initial valve cal value for any injection pump is 123. When controlled via a CANbus connection, theSidekick Pro pump should be set up as a “Standard Valve” on the control console to ensure proper control ofthe injection pump.Note: The initial valve cal may be adjusted to refine Sidekick Pro system response for various applicationneeds. Refer to the specific control console manual for more information.Rate CalEnter the desired rate of injected chemical in ounces per acre [deciliters/hectare].Verifying Flow Rate LimitsBefore beginning to apply product, use the following formula to verify that Sidekick Pro is capable of applying atthe target application rate and speeds:Be sure that the calculated volume per minute is within operating tolerance of the injection pump installed onthe implement.Flow Output RangeP/N 063-0173-0815-200 oz./min.[1.5-59 dl/min.]P/N 063-0173-1031-40 oz./min.[0.3-11.8 dl/min.]Volume Minute Rate Speed Width5940 60 000 --------------------------------------------------------= |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine