5. DVI cable (plugs into the DVI input on GPM processor unit).6. Network selector switch (must be in UP position for connectionto a SeaTalkhs network).7. Monitor’s DVI input.8. Monitor’s VGA input.9. Monitor.10. Power connection.IP address labelThere are 3 labels on your monitor containing the IP address. Youwill need to know the IP address when setting up the G-Seriessystem and associated monitors.Example IP address labelRe ta in for Ins ta lla tion a nd P e rma ne nt Re cordIP Addre s s : 192.168.101.82Loca tion:• The label on the front of the monitor should be left in place forreference when commissioning the G-Series system.• The removable label on the rear of the monitor should be removedand attached to the handbook or a suitable log book for futurereference. Ensure that you write the monitor location onto thislabel.• The remaining label on the rear of the monitor should be left inplace.IP selector switchThe IP selector switch at the rear of the monitor must be in the UPposition.Screen resolution and aspect ratioG-Series monitor screen resolution and aspect ratio.Each GPM processor unit provides an identical screen resolutionand aspect ratio to both its monitor outputs (DVI and VGA).If you want to connect 2 displays to your system featuring differentscreen resolutions or aspect ratios (for example a widescreentelevision and a G-Series monitor), you must use 2 separate GPMprocessor units.G-Series Monitor cablesCables for connecting the monitor to the G-Series system.DVI connection to GPM400Cable Part number Notes5 m (16.4 ft) DVI to DVI(digital) cableE06021 Supplied with themonitor10 m (32.8 ft) DVI to DVI(digital) cableE06022SeaTalkhs cablesCables to connect from the monitor to the SeaTalkhs switch. Theseare required for control of monitor functions with the G-Serieskeyboard.Cable Part number Notes1.5 m (4.9 ft) SeaTalkhspatch cableE060545 m (16.4 ft) SeaTalkhspatch cableE0605550 G-Series installation instructions
