Raymarine ST4000+ Owner's Handbook Manual

Also see for autopilot ST4000+: Owner's handbook Quick reference Owner's handbook Service manual Service manual

Contents

Raymarine ST4000+ Owner's Handbook Manual Manual pdf 85 page image

Chapter 6: Setting-up the ST4000+ 776 Setting-up the ST4000+Chapter 6: Setting-up the ST4000+When you have installed the system, you need to check that thesystem is wired correctly and set up to suit your type of boat.This chapter provide instructions for the following post-installationprocedures:Note: You can perform further customization after the sea trial, asdescribed in Chapter 7: Customizing the ST4000+.6.1 Functional testSwitch on1. When you have installed your ST4000+ autopilot system, switchon the main power breaker.2. If the control unit is active and the system operating, the controlunit will beep and display the pilot type (4000 WHL or 4000 TILL).CAUTION: Wheel drive systemsOne second after power-on the wheel pilot will drive to starboardfor three seconds. This is to allow even wear on the drive belt.3. After displaying the pilot type for two seconds, the control unitwill then display the Standby screen.Troubleshooting• If the head does not beep, check the fuse/circuit breaker.• If the display shows the SEATALK FAIL alarm message, check theSeaTalk connections.D3567-581131_8.book Page 77 Thursday, October 7, 2004 11:03 AM