Raymarine ST80 Installation Manual

Also see for Maxiview ST80: Operation manual Operation & setup Owner's handbook Operation manual Operation manual

Contents

Raymarine ST80 Installation Manual Manual pdf 6 page image

ST80 Active Speed & Depth Transducer Installation 3Chapter 1: Installation1.1 Installing the Speed SensorPlease refer to the instructions provided in speed sensor package forcomplete installation details and recommendations.These instructions should be read thoroughly before any attempt ismade to install the speed sensor.General Points to RememberThe speed sensor should be installed so that it is:• Ahead of the propellers.• At least 150mm (6in) from the keel and ideally forward of the keel.D587• Near the centre line of the vessel.• Clear of all through hull fittings and projections.There should also be sufficient space above the sensor to allow thepaddle wheel assembly to be removed.Alternative active transducers are available from your Autohelmdealer. The range includes: bronze through hull speed and a transommount triducer.