AUTOAUTOAUTOTRACKSTARBOARDSTANDBYNEXT WPT55˚85˚modeD6397-2ntrolTo change theAutopilot HeadingTo follow a Routeset on a ChartplotterautoPress to activatethe Autopilotstandby + autoPress for Wind Vane modecourse change keysPort 1˚ Starboard 1˚Port 10˚ Starboard 10˚x3x3 OK?OK?&Press to adjust calibration,response and gainstandbyPress for Manual Control

quick start guide

display layout

Raymarine SmartPilot ST7002 Quick Start Manual

important information

safety notices

connections to other equipment

Chapter 1: System Connections

The SmartPilot computer

Removing and replacing the connector cover

Computer inputs, outputs and fuses

Connecting the Power and the Drive unit

Grounding the SmartPilot

Fuse Protection

Securing the Cables

Isolated control unit, single power supply (S2 and S3 computers only)

Connecting SeaTalk or NMEA compasses

How to connect NMEA equipment

SmartPilot computer NMEA inputs/outputs

How to connect optional components

External alarm

Selecting clutch voltage (S3 & S3G only)

Secure the cables

WARNING: Calibration requirement

Step 1 - Switch on

NMEA navigator connections

Check the autopilot steering sense

Enter Dealer Calibration mode

Set the drive type

Align the rudder position sensor

Seatrial Calibration

Calibrating the compass

Adjusting the heading alignment

Manual set-up: Non-G Systems

Adjusting the rudder gain

Adjusting the counter rudder

Further adjustments (Non-G)

Calibration basics

Accessing the Calibration modes

Display Calibration

Display Calibration screens

Data

User Calibration

Dealer Calibration

Dealer Calibration screens and settings

Drive type

Rudder limit

Rudder damping

Response level

Off course warning angle

AutoRelease (I/O drives only)

Wind selection

AutoAdapt

System reset

Dealer Calibration defaults

Dealer Calibration options

Chapter 4: Fault Finding & Maintenance

SmartPilot alarm messages

Maintenance

Product support

SmartPilot Specifications

WARNING: Potential ignition source

Glossary

Index

raymarine world wide warranty

product warranty

warranty limitations

SmartPilot ST7002

product disposal

handbook information

Introduction

Extended systems

Start-up mode

What does the display tell me

Using the SmartPilot to steer your boat

Can I dodge an obstacle and then resume course

Off Course warning

How do I prevent accidental gybes

Can I adjust the display lighting & contrast

How do I adjust the contrast

How do I follow a route set on a Chartplotter

How do I leave Track mode

Tidal stream compensation

What happens when I arrive at a waypoint

What is the Waypoint Advance warning

Using Wind Vane mode – sail boats

How do I leave Wind Vane mode

What is a Wind Shift warning

Operating hints for Wind Vane mode

Can I display Waypoint names

User Calibration Options

Gybe inhibit (SAILBOAT only)

Chapter 3: Fault Finding & Maintenance

General maintenance

EMC advice

software information

Product details table

Specifications


Contents quick start guide display layout	AUTOAUTOAUTOTRACKSTARBOARDSTANDBYNEXT WPT55˚85˚modeD6397-2ntrolTo change theAutopilot HeadingTo follow a Routeset on a ChartplotterautoPress to activatethe Autopilotstandby + autoPress for Wind Vane modecourse change keysPort 1˚ Starboard 1˚Port 10˚ Starboard 10˚x3x3 OK?OK?&Press to adjust calibration,response and gainstandbyPress for Manual Control Previous / 2