Raymarine i60 wind Installation And Operation Instructions Manual

Contents

Raymarine i60 wind Installation And Operation Instructions Manual Manual pdf 8 page image

– At least 1 m (3 ft) from any equipmenttransmitting or cables carrying radio signals e.g.VHF radios, cables and antennas. In the caseof SSB radios, the distance should be increasedto 7 ft (2 m).– More than 2 m (7 ft) from the path of a radarbeam. A radar beam can normally be assumedto spread 20 degrees above and below theradiating element.• The product is supplied from a separate batteryfrom that used for engine start. This is important toprevent erratic behavior and data loss which canoccur if the engine start does not have a separatebattery.• Raymarine specified cables are used.• Cables are not cut or extended, unless doing so isdetailed in the installation manual.Note: Where constraints on the installationprevent any of the above recommendations,always ensure the maximum possible separationbetween different items of electrical equipment, toprovide the best conditions for EMC performancethroughout the installationSuppression ferritesRaymarine cables may be fitted with suppressionferrites. These are important for correct EMCperformance. If a ferrite has to be removed for anypurpose (e.g. installation or maintenance), it must bereplaced in the original position before the productis used.Use only ferrites of the correct type, supplied byRaymarine authorized dealers.Where an installation requires multiple ferrites to beadded to a cable, additional cable clips should beused to prevent stress on the connectors due to theextra weight of the cable.Connections to other equipmentRequirement for ferrites on non-Raymarine cablesIf your Raymarine equipment is to be connectedto other equipment using a cable not supplied byRaymarine, a suppression ferrite MUST always beattached to the cable near the Raymarine unit.Caution: Sun covers• To protect your product against thedamaging effects of ultraviolet (UV)light, always fit the sun covers when theproduct is not in use.• Remove the sun covers when travellingat high speed, whether in water or whenthe vessel is being towed.Caution: CleaningWhen cleaning this product:• Do NOT wipe the display screen witha dry cloth, as this could scratch thescreen coating.• Do NOT use abrasive, or acid orammonia based products.• Do NOT use a jet wash.Caution: CondensationCertain atmospheric conditions maycause a small amount of condensationto form on the unit's window. This willnot damage the unit and will clear afterthe unit has been switched on for a shortperiod.Declaration of conformityRaymarine UK Ltd. declares that this product iscompliant with the essential requirements of EMCdirective 2004/108/EC.The original Declaration of Conformity certificatemay be viewed on the relevant product page atwww.raymarine.com.Product disposalDispose of this product in accordance with theWEEE Directive.The Waste Electrical and Electronic Equipment(WEEE) Directive requires the recycling of wasteelectrical and electronic equipment. Whilst theWEEE Directive does not apply to some Raymarineproducts, we support its policy and ask you to beaware of how to dispose of this product.Warranty registrationTo register your Raymarine product ownership,please visit www.raymarine.com and register online.It is important that you register your product toreceive full warranty benefits. Your unit packageincludes a bar code label indicating the serial numberof the unit. You will need this serial number whenregistering your product online. You should retainthe label for future reference.IMO and SOLASThe equipment described within this documentis intended for use on leisure marine boats andworkboats NOT covered by International MaritimeOrganization (IMO) and Safety of Life at Sea(SOLAS) Carriage Regulations.8 i60