7INSTALLATIONInstallation CodesInstallation must be in accordance with local codes, or,in the absence of local codes, with the latest editionsof the National Fuel Gas Code, ANSI Z223.1/NFPA 54,and the National Electrical Code, ANSI/NFPA 70. InCanada installations must conform with the currentCAN/CSA B149 and the Canadian Electrical CodePart 1 CSA C22.2 No.1. Where required by the author-ity having jurisdiction, the installation must conform toAmerican Society of Mechanical Engineers SafetyCode for Controls and Safety Devices forAutomatically Fired Heaters, CSD-1.Installation baseThe heater should be mounted on a level, non-com-bustible surface. Heater must not be installed oncarpeting. The heater can be installed on a com-bustible surface only when the appropriate listed floorshield base is provided. An optional listed floor shieldbase is available for factory installation with the heateron all indoor models. Do NOT use the shipping basecrate as an installation base.In addition, the heater shall be installed such that thegas ignition system components are protected fromwater (dripping, spraying, rain, etc.) during applianceoperation and service (circulator replacement, controlreplacement, etc.).NOTE: The heater should be located in an areawhere water leakage will not result in damage to thearea adjacent to the appliance or to the structure.When such locations cannot be avoided, it isrecommended that a suitable drain pan, adequatelydrained, be installed under the appliance. The panmust not restrict air flow.General SpecificationsThe Raypak water heaters are design certified andtested under the latest requirements of the AmericanNational Standard, ANSI Z21.10.3/CSA 4.3. Eachheater has been constructed and pressure tested inaccordance with the requirements of Section IV of theAmerican Society of Mechanical Engineers Code, andfactory fire tested.All Models (Approved)All models are National Board approved. Temperatureand pressure gauge is standard. Intermittent ignitiondevice is standard on models 0514 and up.Model 0133 has 4-pass heat exchanger, 1 tube perpass.Models 0181-0401 have 2-pass heat exchangers, 5tubes first pass, 4 tubes second pass.Models 0514-1826 have 2-pass heat exchangers, 5tubes first pass, 4 tubes second pass.Models 2100-4001 have 2-pass heat exchangers, 9tubes per pass.Models 0926-4001 have optional single pass with castiron headers only.Hot Water Supply HeatersAll Raypak hot water supply heaters are ASME ratedand design certified as hot water heaters, with 125 PSIpressure relief valves.TYPE WH1 with ON/OFF CONTROLSModels 0133-4001To be used with storage tank systems. Available withintegrally mounted pump, factory mounted and wiredfor models 0133-1826. Models 0181, 0261, 0331 and0401 are Low NOx Hot Water Heaters.TYPE WH2 with MODULATINGCONTROLSModels 0133-4001Hot water supply heater with 110°-170°F gas modula-tion. Available with integrally mounted pump, factorymounted and wired for models 0133-1826. To be usedwith storage tank systems.TYPE WH3 with 2-STAGECONTROLSModels 0181-4001Hot water supply heater with low-high fire for 2-stagecontrol. Available with integrally mounted pump, facto-ry mounted and wired for models 0181-1826. To beused with storage tank systems.