1 To adjust the play, thread thebrake lever adjuster in or out 1/4to 1/2 turn until the desired brakeadjustment is attained. Mostadjustments are complete at thisstep. If brake still needs furtheradjustment, proceed to step 2.2 If the brake lever adjuster isthreaded outward and the brakestill has too much slack, use theback brake adjuster at the rearbrake for additional adjustment.WARNING: The brakeis capable of causing the electricmotorbike to skid the tire andthrowing an unsuspecting rider.Practice in an open area free fromobstacles until you are familiar withthe brake function. Avoid skiddingto a stop as this can cause you tolose control or damage the rear tire.5REPAIR AND MAINTENANCECheck the Razor web site for any updates on the latest repair and maintenance procedures.Turn power switch off before conducting any maintenance procedures.ā Adjusting the Brakes2 If the brake has too much slack,loosen the rear anchor bolt and pullthe brake wire tighter. The distanceof the brake wire between the endof the cable and the anchor boltshould be between 37 and 44 mm.37-44 mmMX5003 If the brake rotor is dragging onthe brake pads, use your fi ngers totwist the calliper adjuster in eitherdirection until rotor is centeredbetween pads.Dirt Rocket MX3504 Inspect the brake pads (A) forproper alignment against the wheelor excess wear. To realign brakepads, loosen the fi xing nut (B) andadjust the pad to contact the rim.Retighten and test the brakefunction, then readjust as needed.1 To adjust the play, thread thebrake lever adjuster in or out 1/4to 1/2 turn until the desired brakeadjustment is attained. Mostadjustments are complete at thisstep. If brake still needs furtheradjustment, proceed to step 2 forrear brake or step 4 for front brake.