4q Attaching the Rear Caster WheelsRequired Tools: 5mm Allen wrench1 Remove the four couplingbolts from the frame using two5mm Allen wrenches; one on topand one on bottom.2 Align the four holes in seatwith the four holes in frame. Insertcoupling bolts through the top andbottom of the frame.q Attaching the SeatRequired Tools: (2) 5mm Allen wrenchASSEMBLy AND SET-UP3 Tighten bolts using two 5mmAllen wrenches; one on top andone on bottom.2 Using a 5mm Allen wrench,tighten the hex bolt located on theunderside of the wheel cover untilthe caster bolt is all the way insidethe frame.Note: There should be no visiblethreading between the frame andthe wheel cover (See Inset)3 If you’re having trouble thread-ing the caster into frame, use a ragor small brush with a little WD-40® to remove any excess particlesthat may be caught in or around thethreading within the frame.Need Help? Visit our web site for replacement parts and product support at www.razor.com, or call toll-freeat 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.1 Insert the caster bolt into theframe. If aligned correctly, the casterthread should go half way into theframe with no resistance.Note: Make sure the spring washeris on the caster bolt before insertingthe caster.Meijer.com