3Set-Up and USage2 Place the handlebar pad over thehandlebars and secure tightly withthe velcro cover.1 Align the holes on the handlebars and the T-bar. Insert handlebar boltsinto the top of the handlebar and through the T-bar. Install the washers andnuts onto the bottom of the handlebar bolts. Tighten securely into placeusing a 10 mm wrench.q Assembling the HandlebarsTools Needed: 10 mm wrench3-13-23-33-43-53-53-3 3-13-2q Assembling the Rear WheelsTools Needed: Two (2) 10 mm wrenches1 Remove the locknut, spring washer and washers (x3) from one side of the axle bolt. Insert the axle bolt throughthe rear wheel. Insert the large washer (3-5) onto the axle bolt between the frame and rear wheel and slide the axlebolt through the frame. Slide the other large washer and wheel onto the axle bolt. Note: Wheels are interchangeable.2 Insert the small washer (3-3), spring washer (3-2) and locknut (3-1) ontothe axle bolt and tighten securely using two (2) 10 mm wrenches.3 Make sure the locknut, springwasher and small washer are securelytightened against the wheel.3-1 - Locknut3-2 - Spring washer3-3 - Washer (small)3-4 - Axle boltWheel3-5 - Washer (large)Rear wheel hardware sequenceFrameNote: For further assistance, pleaserefer to page 5 for parts breakdown.