Recoda M602 User Manual
                                       | |
Mini SD card mobile DVR M602 user manual5 Frequently Asked Question1. How to operate the motion detection recording?A: There are mainly two steps for setting the motion detection recording: Set the sensitivity, area and the recording channel to be triggered of thecorresponding channel in the “MTD” page. Set the time of the corresponding channel triggering the motion detection recordingin the “Schedule” page.Note: the alarm recording setting is similar to the motion detection recording setting. Youneed to set the recording channel in the “Alarmin” page, and set the time in the“Schedule” page.2. How to modify the information in the edit box when use remote control?A: Use 【FN】 to switch the type of the input character; use the 【MENU】 key to exitthe edit mode after edit is complete.3. After connect the HDD and start the recording, why doesn’t it record?A: There are three possibilities:When the HDD connected is new, it cannot record without format. Thus, you need toformat the new HDD first;When set overwrite when the device is full in the “Setup” interface, the device will stoprecording when the HDD is full;When the HDD connected is defective, it will not record while the system can preview.4. Why can’t the SD card be formatted?A: When the capacity of the SD card is less than 4G, it cannot be formatted.5. Why can’t the connected mobile HDD or the U disk backup?A: When the file system format of the mobile HDD or the U disk is NTFS, they cannotbackup.6. Why sudden shutdown occurs sometimes?A: When ACC is under stalling status, up to the time set of “ACC Delay”, it will autoshutdown.7. Why does the device will auto start after shutdown?A: When conduct soft shutdown, ACC is still under ignition status, thus the device willauto start after shutdown.8. Why doesn’t the device shutdown immediately after stalling?A: There is “ACC Delay” setting in the “Setup”, which default to 5 minutes, namely, it willshutdown after 5 minutes since receiving the ignition signal; to shutdown immediately afterstalling, you only need to set the time of “ACC Delay” to be 0.9. Why is there only audio but no video when the client plays the recording file?A: Because the DirectDraw acceleration is not enabled. The enable method is: inputdxdiag in the running interface, open DirectX diagnostic Tool, select “Show”, “Enable” theDirectDraw acceleration in the DirectX function. It is shown as the below picture:8 |
Related manuals for Recoda M602
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine