Record Power RSDE2/A Original Instruction Manual
                    | |
Contents
| 
1612. Electrical Connection & Wiring DiagramsRSDE1 & RSDE2Machines supplied for use in the UK are fitted with a 3 pin plug conformingto BS1363, fitted with a fuse conforming to BS1362 and appropriate to thecurrent rating of the machine.Machines supplied for use in other countries within the European Union arefitted with a 2 pin Schuko plug conforming to CEE 7/7.Machines supplied for use in Australia & New Zealand are fitted with a 3 pinplug conforming to AS/NZS3112.In all cases, if the original plug or connector has to be replaced for anyreason, the wires within the mains power cable are colour coded as follows:230 V (Single Phase)Brown: Live (L)Blue: Neutral (N)Green and Yellow: Earth (E)The wire coloured brown must always be connected to the terminal marked‘L’ or coloured red.The wire coloured blue must always be connected to the terminal marked ‘N’or coloured black.The wire coloured green and yellow must always be connected to theterminal marked ‘E’ or with the earth symbol:or coloured green / green and yellow.It is important that the machine is effectively earthed. Some machines will beclearly marked with the double insulated logo:In this case there will not be an earth wire within the circuit.In the case of the BS1363 plug for use in the UK, always ensure that it isfitted with a fuse conforming to BS1362 appropriate to the rating of themachine. If replacing the original fuse, always fit a fuse of equivalent ratingto the original. Never fit a fuse of a higher rating than the original. Nevermodify the fuse or fuse holder to accept fuses of a different type or size.Where the current rating of the machine exceeds 13 A at 230 V, or if themachine is designated for use on a 400 V 3 phase supply a connectorconforming to BS4343 (CEE17 / IEC60309) will be used.230 V machines will be fitted with a blue 3 pin connector. The wiring for thistype of this connector will be the same as shown above.400 V, 3 phase machines will be fitted with a red 4 or 5 pin connector. Thewiring for this type of connector is as shown below:400 V (3 phase)Brown: Live (L1)Black: Live (L2)Grey: Live (L 3)Blue: Neutral (N)Green and Yellow: Earth (E)The wire coloured brown must always be connected to the terminalmarked ‘L1’.The wire coloured black must always be fitted to the terminalmarked ‘L2’.The wire coloured grey must always be connected to the terminalmarked ‘L3’.The wire coloured blue must always be connected to the terminalmarked ‘N’ or coloured black.The wire coloured green and yellow must always be connected to theterminal marked ‘E’ or with the earth symbolIf in doubt about the connection of the electrical supply, always consult aqualified electrician. |
Related manuals for Record Power DX4000
manualsdatabase
Your AI-powered manual search engine