Recordex ST-700 Instruction Manual
Also see for ST-650U: Instruction manual
                             | |
Basic Operations10Note: If the IFP does not receive a displaying signal for a certain time, the IFP goes into standby mode.Plug the power cord into an AC Power outlet. Press Power Switch on the IFP.Now the IFP is in standby mode. Wait a moment until the power indicator lights up, then press POWER to turnon the IFP. (Be sure to wait for a few seconds before pressing POWER button. If you promptly press POWERbutton then the IFP may not respond or act wrongly.)Press button again to turn off the IFP and put the IFP in standby mode.To cut off the power completely, press Power Switch on the IFP.123Turning the IFP on or offOperating the Float menuThe first time installationConnect to power source and turn on the IFP, the below installation menu page will display on the screen.1.Slide up from bottom of the screen center by two or more fingers to call .Press and drag to any place of the screen.2. Press to take 2 seconds to be activated on VGA/HDMI/DP/PC channel.3.When displaying at USB interface, touch once at the lower part of the screen, the displaycontrol menu will appear.Call the Volume bar.Call the input source menu.Back to previous.Turn off the Float menu.Call the application history.Call the Home page.(Android Interface)Call the annotation.Select desired menulanguage, then press STARTand turn to next page.Select location and turn tonext page. |
Related manuals for Recordex ST-650U
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine