Red Hat NETWORK ENTERPRISE - USER REFERENCE GUIDE 2.6 User Reference Manual

52 Chapter 4. Red Hat Network Website• Status — Shows which type of Errata Alerts are applicable to the group or confirms that it is up-to-date. Clicking on a group’s status icon takes you to the Errata tab of its System Group Detailspage. Refer to Section 4.4.3.3 System Group Details for more information.The status icons call for differing degrees of attention:• — All systems within group are up-to-date• — Critical Errata available, update strongly recommended• — Updates available and recommended• Group Name — The name of the group as configured during its creation. The name should beexplicit enough to easily differentiate between it and other groups. Clicking on the name of a grouptakes you to Details tab of its System Group Details page. Refer to Section 4.4.3.3 System GroupDetails for more information.• Systems — Total number of systems contained by the group. Clicking on the number takes you tothe Systems tab of the System Group Details page for the group. Refer to Section 4.4.3.3 SystemGroup Details for more information.• Use in SSM — Clicking the Use Group button in this column loads the group from that row andlaunches the System Set Manager immediately. Refer to Section 4.4.4 System Set Manager formore information.4.4.3.1. Creating GroupsTo add a new system group, click the create new group button on the top-left corner. Type a nameand description and click the Create Group button. Make sure you use a name that clearly sets thisgroup apart from others. The new group will appear in the System Groups list.4.4.3.2. Adding and Removing Systems in GroupsIn the System Groups list, click the name of the group to receive the systems. This will take you tothe System Group Details page. Once there, click the Target Systems tab and select the systems tobe added to this group. Although all entitled systems should be listed, only systems at the Enterpriseservice level can be selected for addition. After selecting all of the systems to be added, click the AddSystems button on the bottom right-hand corner of the page. The new systems will then be shown onthe group’s Systems tab.To remove systems from groups, use the Groups tab of the System Details page. Refer to Section4.4.2.6 System Details for instructions.4.4.3.3. System Group DetailsAt the top of each System Group Details page are two links: work with group and delete group.Clicking delete group does just that and should be used with caution. Clicking Work with Groupfunctions similarly to the Use Group button from the System Groups list in that it loads the group’ssystems and launches the System Set Manager immediately. Refer to Section 4.4.4 System Set Man-ager for more information.The System Group Details page contains five tabs:• Details — Basic information about the system group: the group name and group description. Tochange this information, make your changes in the appropriate fields and click the Modify Detailsbutton.