RedMax HEC-EX850 Operator's Manual

BATo assemble the cutting attachmentWARNING: Never use a cuttingattachment without without an approvedcutting attachment guard. If an incorrector faulty cutting attachment guard isfitted this can cause serious personalinjury.1. Fit the drive disc (A) on the output shaft. Makesure that the edge of the drive disc, that fits in thehole of the blade, is facing outwards.a) For model HEC-EX850:BAEDCb) For model HES-EX850:BAC ED2. Lock the blade rotation by inserting the lockingpin (E) in the hole on the drive disc.3. Fit the blade (B) on the drive disc.4. Fit the support flange (C). The support flangemust be fitted so that its outer edge pressesagainst the cutter.5. Fit the locknut / blade mounting bolt (D). Thelocknut / blade mounting bolt has a left-handthread. Tighten the locknut / blade mounting boltto a torque of 15-20 Nm / 12-15 ft-lb.6. Remove the locking pin.To adjust the cutting depth of thecutting attachmentThe cutting depth of the cutting attachment must beadjusted before starting work.1. Loosen the wing nut.a) For model HEC-EX850:b) For model HES-EX850:2. Set the desired cutting depth.3. Tighten the wing nut.MaintenanceIntroductionBelow you will find some general maintenanceinstructions. If you need further information pleasecontact your service workshop.To perform daily maintenance• Check that the blade does not rotate when theengine is idling.• Check that the cutting attachment guard isundamaged and not cracked. Replace the cutting1029 - 001 - 29.01.2019 7