Regency GEM54-NG Owners & Installation Manual

Also see for GEM54-LPG: Owner's manual Owners & installation manual

Regency GemfireTM Gas Fireplace 35INSTALLATIONSCREEN & DOOR FRAME OVERLAY INSTALLATIONINSTALLATION1) Orient the safety screen so the raised part of the screen faces up.2) Place the screen into the back side of the door frame as shownbelow.3) Hold the screen in place in door frame as shown below -install door frame with screen onto unit.5) Door frame and screen installed on the Gemfire 54.4) Install the door frame overlay by hooking the top fl ange over top ofthe glass door, push in the bottom of the door frame overlay to securein place.Door FrameOverlayScreenGlass DoorWarning: Turn off the unit by way of the wall switch or remote.Allow unit to cool at least 10 min. - prior to removingfaceplate.6) Place 2 of the supplied magnets on the lower corners of the DoorFrame Overlay, this will keep the Faceplate in postion after it hasbeen installed.Magnet PositionBefore you start:Stainless must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time. Claims for damageafter installation will not receive consideration.To protect the finish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even whenremoving protective coating).Stainless will discolor a little during normal operation. This is normal and should not be considered a defect.All hand and finger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave afi lm/residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat tothe unit. Failure to do this may result in burn stains which you will be unable to remove. This is not a warranty item.