Regency H2100M Owners & Installation Manual

Contents

10 | Regency Wood Insert & Hearth Heate|10installationGroundFan FanGround GreenNeutralLiveWhiteFanSwitchManual/AutoSwitchBlack BlackHigh (Black)Low (Red)BlackFan Thermodisc(normally open)120V AC60 HzThermo Switch SensorThermo Switch SensorBlower/Fan Wiring Diagramof the clips.3) Ensure that the power cord is not in contactwith any hot stove surfaces.4) Push the Regency logo plate into the twoholes in the front bottom left corner of thefan.Do not turn fan ON until your insert hasreached operating temperature or at least30 minutes after starting fire.FAN / BLOWERYour fan should only be installed once the unit isin place in order to prevent any damage to thefan. To attach, follow the instructions providedwith the fan1) Align the fan support with the offset clipon the bottom of the ashlip.2) Slide the supports into the clips. The tensionholding the clips in place may be adjusted byincreasing or decreasing the offset spacingCAUTION: Label all wires priorto disconnection when servic-ing controls. Wiring errors cancause improper and dangerousoperation.WARNING:Electrical Grounding InstructionsThis appliance is equipped with athree pronged (grounding) plug foryour protection against shock hazardand should be plugged directly intoa properly grounded three-prongreceptacle. Do not cut or remove thegrounding prong from this plug.Installer: Please record unit serial number here before installing blower.Serial No.______________________________