Horizon® HZ33CE-10 Gas Fireplace | 39|39installationOPTIONAL REFLECTIVE PANEL INSTALLATION1. Remove the mesh barrier and flush glass door (see instructions inmanual) remove firebox base tray by removing 6 screws in the locationsshown below.Diagram 2Diagram 3Back PanelDiagram 5Diagram 43. Place the top panel in first, secure with 4 screws.(See Diagram 2 for screw locations)4. With the top panel in place install back panel. Note: The bend inthe metal on the side panels should face inward (toward the burnerof the firebox - see Diagram 5). The back panel fits under the toppanel, push the top panel up to fit back panel into position. (Diagram3)6. The side panels are installed last, slide in as shown in Diagram 5.If the side panels have been installed incorrectly the firebox basewill not fit.7. Reinstall the firebox base and glass door.Before installation, panels must be handled and cleaned as per instructions noted below:Black Enamel Panels• Black Enamel panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time. Claimsfor damage after installation will not receive consideration.• Black Enamel panels will discolor a little during normal operation.This is normal and should not be considered a defect.* All hand and finger marks MUST be cleaned off with a soft cloth. Use an ammonia based cleaner (ie. glass cleaner) to remove anyfingerprints before applying heat to the unit.Failure to do this will result in burn stain on panels which you will be unable to remove. Not protected by product warranty.Diagram 6 - Completed Panel InstallationNote: Diagram is shown without a burner.Diagram 1: Remove the 6 screws - lift out base tray2. Remove 4 screws prior to top panel installation.Do not remove this panel.5. Secure back panel with panel bracket as shown below. This bracketwill come with the appliance and is enclosed in manual package.Diagram 3