Regency Horizon HZ30E-NG Owners & Installation Manual

Also see for Horizon HZ30E: Owners & installation manual Owners & installation manual

Contents

46 Regency Horizon™ HZ30E Gas FireplaceINSTALLATIONREFLECTIVE PANEL INSTALLATION1) Remove the faceplate and glass door if already installed - seemanual for instructions.2) Install the back panel fi rst. Tilt the panel forward - position the bottomof the panel fi rst. Use care not to scratch or mar the panel on thepilot shield.3) Install the left side panel - secure in position with one panel clip andone screw, as shown in the diagram below.4) Install the right side panel - secure in position with one panel clipand one screw.5) Reinstall glass door - reinstall faceplate.6) Final installationBefore installation, panels must be handled and cleaned as per instructions noted below:Stainless Steel Panels Black Enamel Panels• Stainless panels must be inspected for scratches and dimples priorto installation. All claims to be recorded at this time.Claims for damage after installation will not receive consideration.• Black Enamel panels must be inspected for scratches and dimplesprior to installation. All claims to be recorded at this time.Claims for damage after installation will not receive consideration.• To protect the finish during installation and handling - cottongloves MUST be worn at all times while handling the panels (even whenremoving protective coating).• Use a hair dryer to remove the protective coating from the panels.• Stainless panels will discolor a little during normal operation.This is normal and should not be considered a defect. • Black Enamel panels will discolor a little during normal operation. Thisis normal and should not be considered a defect.* All hand and fi nger marks MUST be cleaned off with a soft cloth anda stainless steel cleaner. Most stainless steel cleaners leave a film/residue on the surface of the panels. Use an ammonia based cleaner(ie. glass cleaner) to remove this film before applying heat to the unit.Failure to do this will result in burn stains on panels which youwill be unable to remove. Not protected by product warranty.* All hand and fi nger marks MUST be cleaned off with a soft cloth. Usean ammonia based cleaner (ie. glass cleaner) to remove any fi ngerprintsbefore applying heat to the unit.Failure to do this will result in burn stain on panels which youwill be unable to remove. Not protected by product warranty.