Regency P121-NG10 Owners & Installation Manual

Contents

Regency P121-NG10 Owners & Installation Manual Manual pdf 33 page image

Regency ® P121-10/P131-10 Zero Clearance Direct Vent Gas Fireplace | 3333|installationGLASS DOORREMOVAL1) Remove the 8 screws that secure the glassdoor.2) Pull the door slightly out on an angle andthen lift up and pull completely out.3) P131: Remove the 6 screws that secure theglass door and repeat step 2.FINISHING TRIM1) Slide the Side Finishing Trim up into the slotin the top flange of the fireplace. Push tightagainst the magnet at the base of the unit.LOUVERS & GRILLS1) Attach the screws provided to the top leftand right corners.NOTE: Do not tighten the screw entirely,ensure that some room is left to be able tohang the grill or louver over the screw.2) Hang the Top Louver or Grill onto the 2screws in the top fireplace opening.3) Attach the Bottom Louver or Grill tothe hinges on the bottom flange of thefireplace.4) Attach the screws provided to the top andbottom, left and right corners similar tostep 1.5) Hang the top and bottom louver or grill ontothe screws in the top and bottom, left andright sides of the fireplace opening.The Top and Bottom Side Louver or Grill isinstalled the same way.2) Slide the Corner Finishing Trim up into theslot in the top flange of the fireplace. Pushtight against the magnet at the base of theunit.Slide Trim intoslot.Push trim tightagainst magnet.Slide Trim intoslot.Push trim tightagainst magnet.