Regency P121 Owners & Installation Manual

Also see for P121LC: Owners & installation manual Owners & installation manual Owners & installation manual

Regency P121 Owners & Installation Manual Manual pdf 26 page image

Regency P121-1/P121LC-1/P121RC-1/P131-1 Zero Clearance Direct Vent Gas Fireplace26GLASS DOORREMOVAL1) Remove the 8 screws that secure theglass door.INSTALLATION2) Pull the door slightly out on an angle andthen lift up and pull completely out.3) P131 & P121LC/P121RC Corner Model:Remove the 6 screws that secure theglass door and repeat step 2.FINISHING TRIM1) Slide the Side Finishing Trim up into the slotin the top flange of the fireplace. Push tightagainst the magnet at the base of the unit.LOUVERS & GRILLS1) Attach the screws provided to the top leftand right corners.NOTE: Do not tighten the screw entirely,ensure that some room is left to be ableto hang the grill or louver over the screw.2) Hang the Top Louver or Grill onto the 2screws in the top fireplace opening.3) Attach the Bottom Louver or Grill to thehinges on the bottom flange of the fireplace.P121-1 & P131-1 Corner Models4) Attach the screws provided to the top andbottom, left and right corners similar to step1.5) Hang the top and bottom louver or grill ontothe screws in the top and bottom, left andright sides of the fireplace opening.The Top and Bottom Side Louver or Grill isinstalled the same way.2) Slide the Corner Finishing Trim up into theslot in the top flange of the fireplace. Pushtight against the magnet at the base of theunit.Slide Trim intoslot.Push trim tightagainst magnet.Slide Trim intoslot.Push trim tightagainst magnet.