L676-1 Sunrise Gas FireplaceRegency L676-1 Sunrise Gas FireplaceFinishing Requirements:Finishing material such as tile, river rock, etc. must not protrudebeyond the front facing flanges on all 4 sides of the firebox opening.If material such as brick, stone, etc. extends past the faceplate depth,when finishing around the faceplate, the minimum opening dimensionnoted below must be adhered to - to ensure the faceplate can beremoved.36 -1/4”34 -9/16”Important:A 3/4" gap must be maintained all around the outer edge ofthe faceplate and the edge of any finishing material thicker than1-1/4").This gap is required to facilitate the installation of the faceplate andto ensure the removal of the faceplate for service access.Note: All non-combustible facing material should butt up cleanlyto the flanges around the firebox opening.Rough edges may be visible, from an angle, through the 1/2" gapbehind the faceplate.To obtain a clean edge, facing material edges may be finishedwith a J-style trim or metal cornerbead (both materials availableat your local building or hardware outlet) see diagram 2.Important: Materials used must be NON-COMBUSTIBLE3/4"Finishing Material(thickness + 1-1/4")Finished Facing Thickness Faceplate Adjustment1/2" Factory Setting1/2" - 7/8" (or less) Adjusted to + 3/8"7/8" - 1-1/4" (or less) Adjusted to + 3/4"To accommodate various thicknesses of facing material - thefaceplate is adjustable to a maximum of 1-1/4" and a minimumof 1/2" .See chart below.