Regency U31 Owners & Installation Manual

Also see for Energy U31: Brochure & specs Specification sheet Owners & installation manual Owners & installation manual

Contents

Regency U31 Owners & Installation Manual Manual pdf 7 page image

7U31/I31 Gas Insert Zero Clearance KitKIT ASSEMBLYINSTALLATIONDiagram 2Diagram 3Diagram 11) Using the screws provided, attach left and right sides tothe rear panel. Side flanges go on the outside. Seediagram 1.2) Install floor. All floor flanges go on the inside. Seediagram 1.3) Install top assembly. Make sure top rear flange is on theoutside of the back panel. Top side flanges go on theinside.4) Install top front standoff assembly, with the drywall stand-off angle facing forward. See diagram 1.5) Move Zero Clearance Assembly into final position andattach to framing. See diagram 3.6) Attach 4"(100mm) -"B" vent adapter. See Venting.Note: Top insulation protrudes about1"(25mm) in order to assure atight seal when faceplate isinstalled. Leakage in this areawill result in possible overheat-ing of the finishing material im-mediately above the frame. Seediagram 1.