U32E-5 FPI Direct Vent Gas Insert 27INSTALLATIONOPTIONAL REMOTECONTROLUse the FPI Remote Control Kit approved forthis unit. Use of other systems may void yourwarranty.The remote control kit comes with a hand heldtransmitter, a receiver and a wall mountingplate.1) Choose a convenient location on the wallto install the receiver and the receptaclebox (protection from extreme heat is veryimportant). Run wires from the fireplace tothat location. Use Thermostat Wire Table.2) Connect the two wires to the gas valve. Seewiring diagrams. Optional wall switch GT/GTM using wire 0.584.907FINAL CHECKBefore leaving this unit with the customer, theinstaller must ensure that the appliance is firingcorrectly. This includes:1) Clocking the appliance to ensure the correctfiring rate (rate noted on label) at 15 minutes.2) If required, adjusting the primary air to ensurethat the flame does not carbon. First allowthe unit to burn for 15 min. to stabilize.3) Check for proper draft.CAUTIONAny alteration to the product thatcauses sooting or carboning thatresults in damage to the exteriorfascia is not the responsibility ofthe manufacturer.CAUTIONDo not connect the millivoltremote control wires forto the 120V wires.3) Install 3 AAA alkaline batteries in transmitterand 4 AA alkaline batteries in the receiver.Install the receiver and its cover in the wall.Switch the remote receiver to "remote"mode. The remote control is now ready foroperation.OPTIONAL WALLTHERMOSTATA wall thermostat may be installed if desired,follow the wiring diagram below. FPI offers anoptional programmable thermostat but any250-750 millivolt rated non-anticipator typethermostat that is CSA, ULC or UL approvedmay be used.14 GA.16 GA.18 GA.20 GA.22 GA.50 Ft.32 Ft.20 Ft.12 Ft.9 Ft.Recommended Maximum Lead Length(Two-Wire) When Using WallThermostat (CP-2 System)Wire Size Max. LengthThermostat Wire TableCAUTIONDo not connect the millivolt wallthermostat wiresto the 120V wires.BATTERY INSTALLATION1) 4 AA batteries must be installed in the battery pack to operate the burner switch.2) Install 2 AA batteries per side and connect as shown below.