13PRECAUTIONS, RESTRICTIONS AND WARNINGSTransportation, storage and operationThis equipment must be transported and stored observing the following directions:- Avoid falls and impacts;- Keep it dry, do not expose it to rain, water drops or wet floor;- Keep it away from water and direct sunlight, and in it original wrapping;- Don’t move it over irregular surfaces, protect it from rain and observe the maximum stack quantityspecified in the packaging;Environmental condition for transportation or storage:- Room temperature range for transportation or storage -29ºC to +60ºC.- Relative humidity range for transportation or storage 20% to 90%.- Atmospheric pressure range 500hPa to 1060 hPa (375 mmHg to 795 mmHg).Environmental condition for storage (among the operations):- Room temperature range for storage -10ºC a +55ºC.- Recommended room temperature range +15ºC a +30ºC.- Relative humidity range for storage 30% a 75%.- Atmospheric pressure range 700 hPa to 1060 hPa (525 mmHg to 795 mmHg).Environmental operation condition:- Room temperature range for functioning +10ºC to +40ºC.- Recommended room temperature range +21ºC to +26ºC.- Relative humidity range for functioning 30% to 75%.- Atmospheric pressure range 700 hPa to 1060 hPa (525 mmHg to 795 mmHg).- Operation altitude: ≤2000m.AttentionThe Equipment maintains its condition of safety and efficacy, provided that it is maintained(stored) as mentioned in this instruction of use. Thus, the equipment will not lose or alterits physical and dimensional features.Sensitivity to environmental conditions in normal situations of useThe equipment has been planned not to be sensitive to interference such as magnetic fields,external electrical factors, electrostatic discharge, pressure or variance of pressure, provided thatthe equipment is installed, maintained, clean, preserved, transported and operated as per thisinstruction for use.Precaution and warnings “during the installation” of the equipment- Check the voltage of the equipment at the moment of executing the electrical installation.- Position the equipment in a place where it will not get wet.- Install the equipment in a place where it will not be damaged by pressure, temperature, humidity,direct sunlight, dust, salts, or sulfur compounds.- The unit should not be submitted to inclination, excessive vibrations, or blows (including duringtransportation and handling).- This equipment was not planned for use in an environment where vapors, anesthetic mixturesinflammable with air, or oxygen and nitrous oxide can be detected.- Before the first use and/or after long interruptions from work such as vacations, clean and disinfectthe equipment.