5WARNING: All of the parts, hardware and components such as thehanger bracket and hanger ball have been provided for your safety andthe proper installation of your new ceiling fan. The use of other parts,hardware or components not supplied by Minka Aire ® with the fan willvoid the Minka Aire ® Warranty.REMEMBER to turn off the power. Follow the steps below to hang yourfan properly:Step 1. Remove two knock-outs from the outlet box to expose the joist.(Fig. 6)Step 2. Use the two wood screws and washers to secure the hangerbracket plate directly to the building joist via the knockout holes fromthe outlet box. (Fig. 7)CAUTION! THE HANGER BRACKET PLATE MUST BE INSTALLED DIRECTLYTO THE BUILDING JOIST USING THE TWO WOOD SCREWS ANDWASHERS PROVIDED.Step 3. Secure hanger bracket to hanger bracket plate using the twohex nuts and washers provided, make sure nuts are securely tighten.(Fig. 8)Step 4. Loosen the two set screws and remove the hitch pin and lockpin in the top coupling of the motor assembly. (Fig. 9)Step 5. Remove hanger ball from downrod assembly by loosening setscrew, removing the cross pin, and sliding ball off rod. (Fig.10)Step 6. Carefully feed fan wires up through the downrod. (Fig. 11)Thread the rod into the coupling, next line up holes and replace lock pinand hitch pin. Tighten set screws.Step 7. Slip coupling cover, canopy cover and canopy onto downrod.(Fig. 12) Carefully reinstall hanger ball onto rod being sure that crosspin is in correct position, set screws are tighten and wires are nottwisted.HANGING THE FAN