Instruction manual Rear - front and rear flail mowersMIDO, GRINO, VINO, MAMUT, RIO- 26 -7.3. Risks present when lubricating If risk of splashing is present, make sure to wear protective eyewear with side guards. When lubricating protect eyes and skin against contact with the substance. Therefore useadequate protective wear with long sleeves and protective footwear. Also use protective gloves.In case of a contact with skin, immediately wash the infected area with plenty of water withsoap. Do not allow the product to contaminate water outlets, water courses and soils. In case of an unintentional release to the environment plug the leak, limit the spillage, and thencollect the oil with non-flammable absorbent material (e.g. sand). The product is flammable. In case of fire, use adequate fire-extinguishing means (e.g. foam,water mist, extinguishing powders). Do not use water jets. Disposal of the used product must be made according to official regulations. Improper disposalof the used oil poses danger to the environment.8. DEFINING TOTAL WEIGHT, AXIS LOAD, TYRE LOAD CAPACITYAND MINIMUM LOADNOTE:When mounting the machine on a tractor using front and/or rear 3-point linkage, a maximumvalue of permissible load cannot be exceeded – tractor's front axis load must be 20% of thetractor's overall weight.Before using the tractor-machine assembly, check whether these conditions are met, whilecalculating and weighing the assembly.For calculations the following data is necessary:T [kg] Tractor's overall weightTP [kg] Front axis load on unloaded tractorTT [kg] Rear axis load on unloaded tractorMP [kg] Total weight of machine mounted on front 3-point linkage or weight of front ballastMT [kg] Total weight of machine mounted on rear 3-point linkage or weight of rear ballastA [m] Distance between tractor's front axis center and center of gravity of machine mountedon front 3-point linkage / front ballastB [m] Distance between tractor's axesC [m] Distance between tractor's rear axis center and centers of ball joints on tractor's lowerlinksD [m] Distance between centers of ball joints on tractor's lower links and center of gravity ofmachine mounted on rear 3-point linkage / rear ballast 23231323232313131M MTTPTTA B C D